13
3.6 Induction mode
The induction mode refers to a working mode in which the reading module enters the
reading by sensing the changes in the brightness of the surrounding environment. When the
scene changes, the reading module starts to read. After the reading is successful and the
output information or the single reading time expires, the reading module needs a certain
interval (settable) to re-enter the monitoring state. If the following conditions do not occur,
the reading module will work in cycles as described above: if the barcode is not scanned
within a single reading time, the reading module will automatically suspend the reading and
enter the monitoring state. In the induction reading mode, the reading module can also
start to read the code after pressing the trigger button and continue to monitor the
brightness of the surrounding environment when the code is successfully output, or the
trigger button is released.
Induction mode
3.6.1. Single reading time
Please refer to section 3.2.1 for the setting of single reading time duration setting.
3.6.2. Reading interval time
Please refer to the setting code of reading interval time in section 3.5.1 to set the reading
interval time.
3.6.3. Same code reading day
For the setting of code reading delay for the same code, please refer to section 3.5.2. to set
the code reading delay for the same code.
3.7. Sensitivity
Sensitivity refers to the degree of change in the detection scene in the induction reading
mode. When the reading module judges that the degree of scene change meets the
requirements, it will switch from the monitoring state to the reading state.
To Next Page
Loading...
