Mode Privileged Mode
12) show rate-limit
This command is used to ingress and egress rate limit information
12.1) show rate-limit port
This command is used to specify an switch interface
Format show rate-limit port <port-ID>
Mode Privileged Mode
e.g. Switch#Show rate-limit port 1
Switch#Show rate-limit port g1
12.2) show rate-limit all
This command is used to display all interfaces’ status
Format show Rate-Limit all
Mode Privileged Mode
13) show running-config
This command is used to display switch running config
Format show running-config
Mode Privileged Mode
14) show snmp
This command is used to display all snmp config
14.1) show snmp groups
This command display all snmp groups
Format show snmp groups
Mode Privileged Mode
14.2) show snmp users
This command display all snmp users
Format show snmp users
Mode Privileged Mode
3) show snmp communities
This command display all snmp communities
Format show snmp communities
Mode Privileged Mode
15) show sntp
This command is used to display switch sntp information
Format show sntp
Mode Privileged Mode
16) show spanning-tree
This command displays Spanning Tree information
16.1) show spanning-tree interface
This command displays RSTP ports information
16.1.1) show spanning-tree interface port
This command specify an switch interface
Format show spanning-tree interface port<port-ID>
Mode Privileged Mode
16.1.2) show spanning-tree interface all
This command display all switch interface
Format show spanning-tree interface all
Mode Privileged Mode
16.2) show spanning-tree mst
This command display MST information
16.2.1) show spanning-tree mst detailed
This command display a MST instance information
Layer 2/2+ Management Switch Series 19
To Next Page
Loading...
Need help?
General
