15
（5） SNTP Configuration
This page is used to configure and display SNTP protocol.
Server IP Address 1: One of the SNTP server address.
Server IP Address 2: One of the SNTP server address.
Server IP Address 3: One of the SNTP server address.
Time Interval: Set the SNTP synchronization time interval in seconds. The default is 1800s.
Time Zone: Set the time zone where the switch is located. The default is +8.
Enable Status: Enable or disable SNTP protocol.
Last Update Time: The time of the last SNTP synchronization.
System Date Time: The system current time.
SNTP Configuration page
（6）Jumbo Frame Configuration:
This page is used for configuring jumbo frame.
Jumbo Frame Bytes Enter the jumbo frame bytes (1522-16383)
Jumbo Frame Configuration page
To Next Page
Loading...
