42
4.13. Spanning Tree Protocol configuration
（1）MSTP global configuration page
Through this page, you can configure some MSTP related information, mainly including:
Whether to enable MSTP.
Configure the bridge priority. Devices with lower priority are more likely to be the root
bridge.
Enable BPDU filtering function on the port in the portfast bpdu-filter default state.
Enable BPDU guard function on the port in the portfast bpdu-guard default state.
Configure the forwarding delay.
Configure the interval for sending MSTP Hello packets.
The errdisable mechanism is started. When a port that starts a BPDU guard receives a BPDU,
it starts the errordisable timer. errordisable restarts this port after the configured timeout.
Configure errordisable timeout time.
Configure the number of seconds the switch waits to receive spanning tree configuration
information before triggering a reconfiguration.
Configure the number of hops specified before a BPDU is dropped in a domain.
Start or shut down and cisco compatible spanning tree protocol.
MSTP Global Configuration Page
To Next Page
Loading...
