Dikai DK-D03S - Page 16

OPERATIONAL MANUAL
- 16 - D03S THERMAL TRANSFER OVERPRINTER
IMPORTANT: Never connect or disconnect the cables to the D03S control box with the power on. Failure to
do this may result in personal injury or machine damage.
4. Communication Connector
To connect with communication systems to get requested print information.
2. External I/O Connector
I/O connector is a D-type 9-pin connector to get external signal and output “WARNING”, “Error” signal.
3. SD Card Connector
Update interface.
4. Ethernet Connector
Connect with Ethernet.
I/O Connector Instruction:
PIN
Description
Color
1
NC
Brown
2
SIG+ print signal +
Black
3
SIG- print signal-
Blue
4
ERR1+ Alarm Output 1 COM 1
Purple
5
ERR2+ Alarm Output 2 COM 1
Green
6
NC
Red
7
ERR1+ Alarm Output 1 NO 2
Orange
8
ERR2+ Alarm Output 2 NO 2
Yellow
9
NC
Grey