OPERATIONAL MANUAL
- 8 - D03S THERMAL TRANSFER OVERPRINTER
2. SAFETY
2.1 OPERATION GUIDELINES
Before operating this unit, read this manual thoroughly. Pay particular attention to the WARNINGS AND
CAUTIONS to prevent possible injury to personnel.
1. Please install the main power within 3 meters near the printer.
2. Please make sure air supply must be limited to not greater than 0.6Mpa under any circumstances.
3. Before any maintenance or repair on any part of the printer, disconnect the printer from the power
supply.
4. Please do not put anything between print head and rubber anvil/ rubber roller when the printer is
powered on. Damage to the print head may occur.
5. Please do not run the printer when any covers are taken off.
6. Please do not place the printer in a hazardous environment. Make sure the printer will not turn, move or
topple.
7. The use of incompatible consumables can damage your printer. Use only consumables approved by
DIKAI Company.
8. Please be aware of the danger of power and rub-out signal which can run the printer.
9. Please do move the printer with two hands to make sure not damage the printer.
10. Please do not ignore or remove warning labels on the printer.
11. Please complete detailed inspection of power in, otherwise it will cause the damage of printers.
12. Please install and check the power pocket by qualified electricians to avoid the danger of electro-shock.
To Next Page
Loading...