Dikai DK-D03S - QUICK SETUP MENU

OPERATIONAL MANUAL
- 30 - D03S THERMAL TRANSFER OVERPRINTER
4.3.2 MENU
4.3.3 QUICK SETUP
Name
Description
Option
Horizontal
Adjust the print in mm in the direction parallel
to the print head
Unit 0.1mm
Gap
Ribbon gap between two prints
Unit 0.1mm
Density
Adjust the amount of energy being transferred
into the print head
50-150，default is 100
Delay
Delay to print after getting the print signal
Intermittent: Unit 1ms
Continuous: Unit 1mm
180°
Preview of printing jobs at 180° rotation, only
for preview, won’t change the actual printing
result
On
Off