Dikai DK-D03S - DIAGNOSTIC PARAMETERS

OPERATIONAL MANUAL
- 38 - D03S THERMAL TRANSFER OVERPRINTER
Name
Description
Option
Print Signal
Check print signal input
YES/ NO
Encoder
Check encoder input
YES/ NO
Head move
Make print head move vertically, works in
continuous mode only; this function only
provides preview, won’t change the vertical
data, if you want to adjust Vertical parameter,
enter “Advanced Settings”.
Valid data ：0-600， click
“OK” to finish (in Continuous
mode only).
Head Out
Check the function of air cylinder and solenoid
valve, air supply is needed.
Click “ok”, head out; Click
“ok” again, head in.
Print Head Voltage
Check supplied voltage for print
head(unavailable yet)
Unit: V
Ribbon Cassette
Check if ribbon cassette is well locked
CLOSE/ OPEN
Line Speed
Print speed in continuous mode
Actual print speed
Ribbon Feed
Rewind ribbon length after finish
initializing(unavailable yet)
Unit: mm
Test For Sensor
Check sensor connection(unavailable yet)
YES / NO
Motor Calibration
Motor should be calibrated when ribbon tension
is abnormal, changing PCB, motor, connection
board and drive cable, refer to 4.6.19 for details.
Show motor calibration data
Specs of machine
Copy machine setup data to USB
IMPORT/ EXPORT
System Log
System log of printer
EXPORT