485 PRINTS OPERATION SYMBOL X
In which X is “+” in case of addition, “-“ in case of subtraction, “x” in case of multiplication.
The 482, 483, 484 and 485 blocks refer to the operation executed with the “calculator” function described in section
15.1, USER MAN.REF.
486 PRINTS CONDITIONED ADDITIONAL TARE +PTbbbbbbbbbbbXXXXXXXXUM + T
487 JUST ADDITIONAL TARE VALUE XXXXXXXX
488 JUST 3
rd
CUSTOMER CONDITIONED DESCRIPTION XXXXXXXXXXXXXXXXXXXXXXXXX + T
in which XXXXXXXXXXXXXXXXXXXX are the 25 description characters; just the entered characters are printed,
expanding from left to right. This block can be printed only once, in input or in output.
489 JUST 3
rd
HEADING CONTINGENT ON CUSTOMER DESCRIPTION3
490 JUST 3
rd
CUSTOMER DESCRIPTION XXXXXXXXXXXXXXXXXXXXXXXXX
in which XXXXXXXXXXXXXXXXXXXX are the 25 description characters; just the entered characters are printed,
expanding from left to right; if the material is not selected, the block is ignored. The block is printed only once,
either in input or output.
509 PRINT ONLY WEIGHT INPUT OR OUTPUT AT DEPENDING ON DIRECTION XXXXXXXX
510 PRINT THE BIGGEST ONE WEIGHT XXXXXXXX
between weigh in input – output (always gross)
511 PRINT THE SMALLEST ONE WEIGHT XXXXXXXX
between weigh in input – output (always tare)
512 PRINT THE BIGGEST ONE WEIGHT XXXXXXXX
between weigh in input – output for the second weight (always gross)
513 PRINT THE SMALLEST ONE WEIGHT BETWEEN XXXXXXXX
between weigh in input – output for the second weight (always tare)
9.4 BLOCKS WITH PARAMETERS
When entering the following blocks manually in a print ticket, these require that an additional numeric value be entered
(specified in detail in the block’s description) in order to define the print ticket which one wants to obtain.
EXAMPLE
Entry of the 600 “PRINT n TERMINATORS” block:
- Enter the 600 block in a ticket and confirm with OK/menu.
- The indicator does not pass by the block present in the following line, but shows “P 000”.
- Enter a value between 001 and 050; for values outside this interval the indicator shows “-Error-”, restoring the block
before entering the block 600.
- By entering a valid value, the block will print a number of terminators equal to the one previously entered.
600 PRINTS n TERMINATORS Values valid from 001 to 050
601 PRINTS n LF CHARACTERS Values valid from 001 to 050
602 PRINTS n TAB CHARACTERS Values valid from 001 to 050
603 PRINTS n SPACE CHARACTERS Values valid from 001 to 050
604 PRINTS n “_” CHARACTERS Values valid from 001 to 050
605 LEFT MARGIN FOR LX300 Values valid from 001 to 255
606 NET WEIGHT ON X DIGITS Valid values in the nXX format
607 GROSS WEIGHT ON X DIGITS Valid values in the nXX format
608 TARE WEIGHT ON X DIGITS Valid values in the nXX format
in which n can be:
0 Value with decimal point and spaces
1 Value with decimal point and zeros in the place of spaces
2 Value without decimal point and zeros in the place of spaces
XX is the field length (maximum enterable value is 20); if the weight value is greater than the number of entered
digits, the complete value is printed anyways.
################
EXAMPLE
With a weight value of 100.01, if one wants a length of 10 characters, in the three cases one will have:
To Next Page
Loading...
Need help?
General
