© 2006 Directed Electronics—all rights reserved
44
remote control
The remote control buttons that will operate the features of your security and remote start system are
described below. The buttons will operate in this configuration when the remote control is programmed
using the step 1 Auto-learn routine.
To configure the buttons differently refer to the information in the remote control learn routine section
of this manual.
A remote that uses the standard configuration operates similarly to many factory keyless entry remotes.
A standard configuration remote control allows arming, disarming, trunk release and Remote Start activa-
tion with separate buttons. When programmed for standard configuration, the remote control buttons are
assigned to the following functions:
operates Arm/Lock, Panic ON/Panic OFF
operates Disarm/Panic OFF
operates Remote Start
operates Channel 2—trunk release
and
operate Timer Mode
and operate Short Run/Turbo timer
and
operate Channel 4
and
operate Channel 5
and and
operate rear defogger
and operate Channel 6
To Next Page
Loading...
