Directed Electronics PYTHON 1090 - Menu #3 - Remote Start Options

© 2006 Directed Electronics—all rights reserved
53
menu #3 - remote start options
FEATURE ONE-CHIRP SETTING (DEFAULT) TWO-CHIRP SETTING
3-1
Engine checking ON Engine checking OFF
3-2
Engine checking TACH Engine checking VOLTAGE
3-3*
Run time: 12 minutes (1) Run time: 24 (2) or 60 (3)
minutes
3-4
Parking lights flashing Parking lights constant
3-5
Crank time: 0.6 seconds (1) 0.8 (2), 1.0 (3), 1.2 (4), 1.4 (5),
1.6 (6), 1.8 (7), 2.0 (8), 4.0 (9) sec.
3-6
Voltage check - high Voltage check - low
3-7
Short Run/Turbo–1 min. (1) 3 (2), 5 (3), 10 (4) min.
3-8
Activation pulse count–1 Activation pulse count: 2
3-9
2
nd
Ignition/Acc output: ignition Accessory
3-10
Acc state during wait to start: OFF ON
3-11
2
nd
status output: Normal (1) Rear defogger: latch 10 min. (2)/
pulse
(3)
3-12 Anti grind: ON
Anti grind: OFF
3-13*
Diesel timer Wait-to-Start input (1) Timed 15 (2), 30 (3), 45 (4) seconds
3-14
Timer mode—Timed Starts Temperature Starts
3-15**
Run Time (Timer Mode) 12 minutes (1) 3 (2), 6 (3), 9 (4) minutes
*NOTE: The Bitwriter® can set 1-90 seconds. For feature 3-3 it can also set time for 1-60 minutes
**NOTE: The Bitwriter® can set 1-16 minutes.