67
Controlling Other Components
3 On the DISH remote, press and hold the
mode button for your equipment for about
three seconds until all the mode buttons
light up, and then release it.
Your selected mode button will blink. For
example, if you want to program TV mode on
the DISH remote to control your TV, hold the
TV button down for three seconds.
4 To start learning commands for this mode:
• If you've found a code for that
device, first program the code.
Now press and release RECALL,
then press and hold RECORD for
about three seconds.
• If you have not programmed a
code for that device, press and
hold RECORD for three seconds.
To find and program the device code, use the
instructions for Setting Up Using Device Code
Tables or Setting Up Using Device Codes
Scan.
The mode button that you selected in step 3
should remain lit while learning. If the light goes
out, start over the learning process with step 3.
5 Point the front of the original device remote
to face the small square (IR window) on the
top, left-hand side of the DISH remote, as
shown on page 66.
Both the DISH remote and the original device’s
remote control should remain on a flat, stable
surface for the duration of the learning process.
6 On the DISH remote control, press the but-
ton you want to teach.
Your DISH remote control must learn
commands one button at a time.
7 On the original device’s remote control,
press and hold the button you want
learned.
• If the DISH remote learns the
command, the mode light blinks off
and then back on.
• If the mode light blinks three times
or remains lit, the DISH remote did
not learn the command.
You may need to try pressing the button on the
original device’s remote several times for the
DISH remote to learn the command.
8 After a button has learned a command suc-
cessfully, repeat step 6 and step 7 until all
commands you want have been learned.
If the DISH remote control times out while
learning commands, the mode light will go out,
and then you must start over with step 3.
To Next Page
Loading...
