EC-BOS-9 Install and Startup Guide Chapter 4 System shell
• If no changes, or reboot is not necessary,type L to Logout.
• If changes require rebooting, select the Reboot option, type y at the Are you sure you want to
reboot [y/n] prompt, and press Enter.
The terminal (PuTTY) window displays shutdown-related text.
Step 11 Click the Close control (upper right corner) in the terminal session (PuTTY) window and click OK in
the PuTTY Exit Confirmation popup window.
Step 12 Unplug the USB connector from the EC-BOS’s DEBUG port.
Updating network settings using EC-BOS-9 system shell
Using system shell to update network settings prompts you for each setting sequentially, starting with
hostname.
Prerequisites: You have connected to the controller using the system shell.
Step 1 To access most of the same IP networking options available in the Commissioning Wizard step that
configures TCP/IP settings, select system shell menu option 2.
The Network Configuration Utility displays. Following is an example of the flow with some fictional
addresses:
Enter Choice : 2
Network Configuration Utility
Enter new value, '.' to clear the field or '' to keep existing value
Hostname < TechDocsJ9 > :
Save these settings [Y/n]? y
Committing to disk ...
NET1 Ethernet interface en0
IPv4 address (clear to use DHCP) < nnn.nn.nn.nn > :
IPv4 subnet mask < 255.255.252.0 > :
IPv4 Domain :
Primary IPv4 DNS Server :
Secondary IPv4 DNS Server :
IPv4 Route < nnn.nn.nn.n > :
Enable IPv6 addressing on this adapter [Y/n]?
IPv6 address in CIDR notation address/prefix-length (clear to use DHCP) :
IPv6 Domain :
Primary IPv6 DNS Server :
Secondary IPv6 DNS Server :
IPv6 Route :
Configure Secondary Ethernet interface [Y/n]? n
Confirm new configuration
network:
version: 2
renderer: NetworkManager
ethernets:
en0:
match:
driver: imx-dwmac
set-name: en0
dhcp4: false
dhcp6: true
link-local:
August 14, 2023 39
To Next Page
Loading...
Need help?
General
