EC-BOS-9 Install and Startup Guide Chapter 2 Commissioning
Reviewing and finishing the Commissioning Wizard
The Commissioning Wizard displays a summary of all the actions to be performed by the wizard.
Prerequisites: You are stepping through the Commissioning Wizard.
Step 1 Read through the summary of changes, using the scroll bar to see the steps near the end.
Step 2 If any change is needed, click the Back button until the step window to change opens, make the
change and click the Next button until this review window opens again.
Step 3 If no change is needed, click Finish.
The Commissioning Wizard commissions the controller. While the wizard works it posts progress up-
dates in a Completing Commissioning widow. When completed, the wizard reboots the controller,
and makes a Close button available.
Do not remove power from the controller during this reboot, which may take up to seven or more mi-
nutes to complete. Removing power could make the unit unrecoverable. If desired (and convenient),
you can use a serial shell connection to the controller to monitor progress as files are installed and
the unit is prepared.
Note that firmware upgrades occur before the platform daemon starts in the controller. Therefore, it is
safe to interrupt power any time after you can re-open a platform connection to the controller.
Step 4 To exit the wizard, click the Close button.
When the controller reboots, your platform connection to it closes.
August 14, 2023 29
To Next Page
Loading...
Need help?
General
