12
IP1950EN - 2013-09-13
5.5 VALOR - VALOR H wings installation and adjustment
VALOR 2 WINGS
VALOR 1 WING - RIGHT OPENING
VALOR 1 WING - LEFT OPENING
Make sure that the central wheel [d] is adjusted as illustrated in the diagram.
Fix the door wing to the carriage with screws [a].
The outer wheel of the carriage must not protrude beyond the dimension of the door wing.
Adjust the horizontal position of the door wing in accordance with the measurements indicated in
diagram VALOR 2 for 2 door wing automations, VALOR 1 RH for right-hand opening automations
and VALOR 1 LH for left-hand opening automations. Secure the adjustment with screws [a].
Loosen screws [b], adjust the vertical position of the door wing by means of screw [c] and fix the
adjustment with screws [b].
Check, by moving the door manually, that the movement is free and without friction and that al
the wheels rest on the guide.
WARNING: Leave a gap of at least 10 mm between the glass door wings when closed to avoid
contact of the glass.
150200
LM
OPEN
200150
LM
OPEN
LM
150 150150 150
LM
OPEN OPEN
a
c d
b b
max 0,5 mm
d
To Next Page
Loading...
