DITEC VALOR - Belt Adjustment; Lock Device Installation

16
IP1950EN - 2013-09-13
5.8 Belt adjustment
5.9 Lock device installation
Loosen screws [a], unscrew screw [b] until the spring is at a compression of 22 mm (if the length
of the automation is lower than 2600 mm) or 20 mm (if the length of the automation is greater
than 2600 mm).
Block the adjustment by tightening screws [a].
WARNING: incorrect adjustment impairs the correct functioning of the automation.
Place the door wing in the closure position.
Fasten the lock device to the box profile by means of the supplied screws [a].
Align the lock pin [b] and the lock bracket [c] and manually check the correct functioning.
Slightly lubricate the lock pin and lock bracket.
LT<2600 = 22 mm
LT≥2600 = 20 mm
b
a
a
bc
a
b c