PROGRAMMING P SERIES
Page 17 of 100
"CCU" - Correct Change Value
This is the function that the control board will use to set a value which will turn on the correct
change indicator. Note: The “CCU” must be equal to or greater than the “ACC”.
Note: If the value set is 00.00, the correct change indicator will never come on.
If the controller determines that it cannot return the exact amount of the correct change value or
any value less than it then the indicator will be turned on.
Press select button 4 and the display will show "##.##' with leading zeros not being displayed.
Press select button 2 or 3 to scroll from.00 to 99.99.
Press select button 4 with the display showing the value you wish to use to accept that value, or
select button 1 to keep the original value displayed. Display will return to "CCU"
Press select button 2 to scroll to "ACC".
"ACC" - Unconditional Acceptance Value
This is the function that the control board will use to set the largest value of any single form of
currency (coin or bill) that can be accepted. . Note: if “ACC” is set to a value greater than
“CCU” the “CCU” value will be automatically set equal to the “ACC” value.
Press select button 4 and the display will show "##.##' with leading zeros not being displayed.
Press select button 2 or 3 to scroll from.00 to 99.99.
Press select button 4 with the display showing the value you wish to use to accept that value, or
select button 1 to keep the original value displayed. Display will return to "ACC".
Press select button 1 to return to "CCOC".
Press select button 2 to scroll to next routine.
*"PREV" - PREVIEW DATA PASSWORD ROUTINE
This function is used to enable viewing of cash collected, product sales, and error codes without opening the
door. To view the data the 4 digit password (4-2-3-1) must be entered with the door closed. Once entered
the "CASH", "SALE", "EROR", and "RTN" menus are available from the front of the vender. To view,
follow instructions for cash counter routine, sales counter routines, error routine and return.
To change "PREV" password:
At "PREV" press select button 4, "####" (representing current four digit password) will show on
display with the far left digit blinking. Press select button 2 or 3 to scroll to number desired for
password. Press select button 4 to accept the flashing digit. The next digit will start blinking, press
select button 2 or 3 to scroll to number desired for password. Press select button 4 to accept the
flashing digit. Continue this process until all 4 digits are set. Then press select button 4 and the
display will return to "PREV" and the new password has been saved. Pressing select button 1 at
anytime during this routine will return to "PREV" with no changes to password occurring.
Press select button 2 to scroll to next routine.
*"LANG" - LANGUAGE
This function is used to set the language that will be used for display messages. Note: This does not change the
menu prompts.
Press select button 4 and the display will show the language currently set in the controller.
Press select button 2 or 3 to scroll through the languages available.
ENG - English ITA - Italian SLO - Slovene
FRN - French PORT - Portuguese FIN - Finnish
GER - German ESP - Spanish NOR - Norwegian
With the language you wish to enter showing on the display, press select button 4 and display will return to "LANG".
Pressing select button 1 at anytime during this routine will return to "LANG" with no changes to password occurring.
Press select button 2 to scroll to next routine.
To Next Page
Loading...