PROGRAMMING P SERIES
Page 22 of 100
This function is used to set the day(s) of the week to start selection blocking.
Press select button 4 and "xxx#" will show on the display, where xxx will be the day
of the week (i.e. MON, TUE, WED, THU, FRI, SAT, SUN, ALL) and # is 0 = disable,
1 = enable. With the display showing the day you wish to set press select button 4.
The # will start blinking. Press select button 2 or 3 to scroll between “xxx0” and
“xxx1”.
Press select button 4 with the display showing the setting you wish to use. Display
will return to "xxx#'.
Press select button 2 to scroll to the next day to set or press select button 1 to return
to "DAY". Press select button 2 to scroll to "HOUR".
"HOUR" - Start Hour and Minute Setting
This function is used to set the hours and minutes to start selection blocking.
Press select button 4 and "hhmm" will show on the display, where hh is the hour
(military time) and mm is the minute. "hh" will be blinking, indicating the hour
setting may be changed.
Press select button 2 to scroll from 00 to 23. With the display showing the hour you
wish to start selection blocking, press select button 4. "mm" will then start blinking,
indicating the minute setting may be changed.
Press select button 2 to scroll from 00 to 59. With the display showing the minute
you wish to start selection blocking, press select button 4. The display will return to
"HOUR".
Press select button 1 to return to "STRT".
Press select button 2 to scroll to "STOP".
"STOP" - Stop Selection Blocking Routine
This function is used to set the day(s) and times to stop selection blocking.
Press select button 4 and "DAY" will show on the display.
"DAY" - Day of Week Stop Setting
This function is used to set the days of the week to stop selection blocking and can be set in the same
manner as Day of Week Start Setting.
"HOUR" - Stop Hour and Minute Setting
This function is used to set the hours and minutes to stop selection blocking and
can be set in the same manner as Start Hour and Minute Setting.
Press select button 1 to return to "STOP".
Press select button 2 to scroll to "SEL".
"SEL" - Selection To Be Affected By Blocking
This function is used to set selection(s) which will be blocked during certain periods of the day.
Press select button 4 and XX# will be displayed, where XX is the selection number and # is the
current setting for the selection number displayed. 0 = disabled, 1 = enabled.
Press select button 2 or 3 to scroll to the select button number setting you desire to change.
Press select button 4 with the select button number showing you wish to change (i.e. 01#) and
the #
will start flashing.
Press select button 2 or 3 to scroll between xx 0 and xx 1.
Press select button 4 with the display showing the setting you wish to use to save that setting.
Press select button 1 with the display flashing the enable setting will keep the original setting.
Display will return to a solid “XX #”.
Press select button 1 to return to "SEL".
Press select button 2 to scroll to "LITX".
"LITX" - Lighting / P.O.S. Display Control
This function is used to turn the lights (if supported) off during selection blocking period 1.
0 = disable or on; 1 = enable or off.
Press select button 4 and the "X" will start flashing.
Press select button 2 or 3 to scroll between "LIT0" and "LIT1".
Press select button 4 with the display showing the setting you wish to use to save the setting.
To Next Page
Loading...