PROGRAMMING P SERIES
Page 23 of 100
Press select button 1 with the display flashing the light setting will keep the original setting.
Display will return to "LITX".
Press select button 1 to return to "BLC1".
Press select button 2 to scroll to "BLC2".
*"BLC2" - BLOCK SELECTION BANK 2 ROUTINE (CON 2 must be enabled - C2 1)
This function is a second set used to set selection(s) which will be blocked during certain periods of the day.
Press select button 4 will enter "ENB#" with # being the current enable setting.
“ENB#" - Blocking Enable Routine.
Set this function using instruction for "ENB#" in "BLC1".
"STRT" - Start Selection Blocking Routine
This function is used to set the day(s) and times to start selection blocking.
Press selection button 4 and "DAY" will show on the display.
"DAY" - Day of Week Start Setting
Set this feature using instructions for "BLC1" "STRT" "DAY".
"HOUR" - Start Hour and Minute Setting
Set this function using instructions for "BLC1" "HOUR" "DAY".
"STOP" - Stop Selection Blocking Routine.
This function is used to set the day(s) and times to stop selection blocking.
Press select button 4 and "DAY" will show on the display.
"DAY" - Day of Week Stop Setting
Set this function using instructions for "BLC1" "STOP" "DAY".
"HOUR" - Stop Hour and Minute Setting
Set this function using instructions for "BLC1" "STOP" "HOUR".
Press select button 1 to return to "STOP".
Press select button 2 to scroll to "SEL".
"SEL" - Selection To Be Affected By Blocking
This function is used to set selection(s) which will be blocked during certain periods of the day.
Set this function using instructions for "BLC1" "SEL".
Press select button 1 to return to "SEL".
Press select button 2 to scroll to "LITX".
"LITX" - Lighting / P.O.S. Display Control
This function is used to turn the lights (if supported) off during selection blocking period 2.
Set this function using instructions for "BLC1" "LIT".
Press select button 1 to return to "BLC2".
Press select button 2 to scroll to "DISC".
*"DISC" - DISCOUNT SETTING ROUTINE (CON 2 must be enabled - C2 1)
This function is used to set the day(s) and times to allow discount prices.
Press select button 4 will enter "ENB#" with # being the current enable setting.
“ENB#” - Discount Setting Enable Routine
This function is used to disable discounting “ENB0” or enable discounting “ENB1”.
Press select button 4 and the current ENB setting will flash.
Press select button 2 or 3 to scroll between “ENB0” and “ENB1”.
Press select button 4 with the display showing the setting you wish to use.
Display will return to a solid "ENB#".
Press select button 2 to scroll to “STRT”.
To Next Page
Loading...