PROGRAMMING P SERIES
Page 25 of 100
Press select button 1 with the display showing the Free Vend setting will keep the original
setting.
Display will return to "FRE#".
Press select button 2 to scroll to "UND#".
"VND#" - Vend Enable Routine
This function is used to set the vender to Override Vending. 0 = disable (allow Vending), 1 =
enable (don’t allow Vending).
Press select button 4 and “#” will start flashing.
Press select button 2 or 3 to scroll between "UNDO" and "UND1".
Press select button 4 with the display showing the setting you wish to use to save that
setting.
Press select button 1 with the display showing the Vend Override setting will keep the original
setting.
Display will return to "UND#".
Press select button 2 to scroll to "BLC#".
"BLC#" - Selection Blocking Over-ride Routine
This function is used to over-ride "BLC1" and "BLC2" if they are being used. "BLCO" is
disabled (allow BLC1 and BLC2), "BLC1" is enabled (don’t allow BLC1 and BLC2).
Press select button 4 and "#" will start flashing.
Press select button 2 or 3 to scroll between "BLCO" and "BLC1".
Press select button 4 with the display showing the setting you wish to use to save that
setting.
Press select button 1 with the display showing the Blocking Override setting will keep the
original setting.
Display will return to "BLC#".
Press select button 2 to scroll to "DSC#".
"DSC#" - Discounting Over-ride Routine
This function is used to over-ride "DISC" if it is being used. "DISC0" is disabled (allow
Discounting) and "DISC1" is Enabled ( don’t allow Discounting).
Press select button 4 and “#” will start flashing.
Press select button 2 or 3 to scroll between "DSC0" and "DSC1"
Press select button 4 with the display showing the setting you wish to use to save that
setting.
Press select button 1 with the display showing the Discounting Override setting will keep the
original setting.
Display will return to "DSC#".
Press select button 2 to scroll to "LIT#".
"LIT#" - Lighting Control Over-ride Routine
This function is used to over-ride "LIT'” if it is being used. "LIT0" is disabled (allow Lighting
Control) and "LIT1" is enabled (don’t allow Lighting Control).
Press select button 4 and “#” will start flashing.
Press select button 2 or 3 to scroll between "LIT0" and "LIT1".
Press select button 4 with the display showing the setting you wish to use to save that
setting.
Press select button 1 with the display showing the Lighting Control Override setting will keep
the original setting. Display will return to "LIT#". Press select button 2 to scroll to " FRG#".
"FRG#" - Refrigeration Control Over-ride Routine
This function is used to over-ride "RFRG” if it is being used. "FRG0" is disabled (allow
Refrigeration Control) and "FRG1" is enabled (don’t allow Refrigeration Control).
Press select button 4 and “#” will start flashing.
Press select button 2 or 3 to scroll between "FRG0" and "FRG1".
Press select button 4 with the display showing the setting you wish to use to save that
setting.
To Next Page
Loading...