PROGRAMMING P SERIES
Page 26 of 100
Press select button 1 with the display showing the Refrigeration Control Override setting will
keep the original setting.
Display will return to "FRG#".
Press select button 1 to return to "OVER".
Press select button 2 to scroll to "SDEP".
"SDEP" - SET COLUMN DEPTH ROUTINE (CON 2 must be enabled – “C2 1” – This must be set before
setting package type to “CUSTOM”)
This function is used to set the product depth for the selected column.
Press select button 4 and the display will show "XX #" where XX is the column number and # is the
product depth for that column.
Press select button 4 and the # (depth) will flash.
Press select button 2 or 3 to set the product depth(1 – 5).
Press select button 4 to accept the displayed depth, or select button 1 to keep the original depth.
Press select button 2 or 3 to scroll through the columns available.
Repeat setting the depth for remaining columns.
Press select button 1 to return to "SDEP".
Press select button 2 to scroll to "RVND".
*"RVND" - REMOTE VEND MECHANISM ROUTINE
This function is used to set the day(s) and times to activate the vend operation in a satellite vending device.
Press select button 4 will enter "STRT”.
“STRT” - Start Satellite Vending Operation
This function is used to set the day(s) and times to start satellite vending.
Press select button 4 and “DAY” will show on the display.
"DAY" - Day of Week Start Setting
This function is used to set the day(s) of the week to start satellite vending.
Press select button 4 and "xxx#" will show on the display, where xxx will be the day
of the week (i.e. MON, TUE, WED, THU, FRI, SAT, SUN, ALL) and # is 0 = disable,
1 = enable.
With the display showing the day you wish to set press select button 4.
The # will start blinking. Press select button 2 or 3 to scroll between “xxx0” and
“xxx1”.
Press select button 4 with the display showing the setting you wish to use.
Display will return to "xxx#'.
Press select button 2 to scroll to the next day to set or press select button 1 to return
to "DAY".
Press select button 2 to scroll to "HOUR".
"HOUR" - Start Hour and Minute Setting
This function is used to set the hours and minutes to start satellite vending.
Press select button 4 and "hhmm" will show on the display, where hh is the hour
(military time) and mm is the minute. "hh" will be blinking, indicating the hour setting
may be changed.
Press select button 2 to scroll from 00 to 23. With the display showing the hour you
wish to start selection blocking, press select button 4. "mm" will then start blinking,
indicating the minute setting may be changed.
Press select button 2 to scroll from 00 to 59. With the display showing the minute
you wish to start selection blocking, press select button 4. The display will return to
"HOUR".
Press select button 1 to return to "STRT".
Press select button 2 to scroll to "STOP".
To Next Page
Loading...