PROGRAMMING P SERIES
Page 27 of 100
"STOP" - Stop Satellite Vending Operation
This function is used to set the day(s) and times to stop satellite vending.
Press select button 4 and "DAY" will show on the display.
"DAY" - Day of Week Stop Setting
This function is used to set the days of the week to stop satellite vending and can be set in
the same manner as Day of Week Start Setting.
"HOUR" - Stop Hour and Minute Setting
This function is used to set the hours and minutes to stop satellite vending and can
be set in the same manner as Start Hour and Minute Setting.
Press select button 1 to return to "STOP".
Press select button 2 to scroll to "SEL".
"SEL" - Selection To Be Affected By Satellite Vending
This function is used to set selection(s) which will be cause a satellite vending operation during
certain periods of the day.
Press select button 4 and XX# will be displayed, where XX is the selection number and # is the
current setting for the selection number displayed. 0 = disabled, 1 = enabled.
Press select button 2 or 3 to scroll to the select button number setting you desire to change.
Press select button 4 with the select button number showing you wish to change (i.e. 01#) and
the # will start flashing.
Press select button 2 or 3 to scroll between xx 0 and xx 1.
Press select button 4 with the display showing the setting you wish to use to save that setting.
Press select button 1 with the display flashing the enable setting will keep the original setting.
Display will return to a solid XX #.
Press select button 1 to return to "SEL".
Press select button 2 to scroll to "RATE".
" RATE " - Satellite Vend Rate
This function is used to set the number of vends from the programmed selection that will
occur before a satellite vend operation is done ( rate = 3, every third vend from a
programmed selection will cause a satellite vend to be done).
Press select button 4 and “XXX" will be displayed, where "XXX" is the current satellite vend
rate. Press select button 2 or 3 to change the vend rate (0 – 255, a vend rate of 0 will disable
the remote vend operation).
Press select button 4 with the display showing the vend rate setting you wish to use to save
that setting.
Press select button 1 with the display showing the vend rate setting will keep the original setting.
Display will show "RATE".
Press select button 1 to return to "RVND".
Press select button 2 to scroll to "PACG".
*"PACG" - PACKAGE TYPE SETTING ROUTINE
This function is used to set the package type for any or all columns in the vending machine.
Press select button 4 will enter " XX #”, where XX is the column number and # is the current package type.
Press select button 2 or 3 to scroll through the column numbers or “ALL” for all columns
Press select button 4 and # will flash allowing the package type to be selected.
Press select button 2 or 3 to scroll through the package types (1 – 5, “C” for custom or “RTN” for returning
without making adjustments.
Press select button 4 to accept the displayed package type or select button 1 to keep the current package
type. If package type is “1” through “5” go to “SAVE” will be displayed instructions.
To Next Page
Loading...