21
will continue.
（3）Warning display
⚫ If an error occurs during the operation, the centrifuge will brake to stop
automatically, and display the error code on the time/display area. The error
code can be checked in the table 10-1, and corrective actions can be applied
accordingly.
8.1.5 End the operation
（1）The centrifuge will brake when it reaches the setting time or key is pressed.
⚫ When the rotor stops rotating, centrifuge will start beeping to alert the operation
has finished.
（2）Open the door
⚫ The door can be released automatically when the operation has stopped.
⚫ With the door closed, you are able to press the key to open it.
⚫ After ending the operation, the program will store the setting parameters of this
operation, and will recall these parameters when restart the program.
（3）Open the door and take out the rotor and samples.
To Next Page
Loading...
