20
⚫ Saving the program
Press and hold the key more than 5 seconds, the current parameters are saved
under the selected program number.
⚫ Loading the program
Press the key shortly, the program number will be increasing, from 1 to 9, then
from 9 to 1, the corresponding parameters changing as well.
8.1.4 Start the operation
（1）Press key to start running
⚫ The door should be locked before rotor starts rotating.
⚫ Timer will operate once the speed setting value is reached, the screen displays
the remaining run time.
（2）View and modify the operation programs
⚫ Pressing key , returns the display to the program interface and displays
settings programs. Press the key to the desired program. When flashing,
rotate the key to modify values. Release the key after 5 seconds, and the
centrifuge will return to normal operation mode and run according to the new
value.
⚫ If the set time value has been modified, the operation time is not affected and
To Next Page
Loading...
