29
EN
RV So Start Accessory Installation
qq
ee
ww
48 Routing the supply wire harness
q
Supply wire harness path
e
Strain relief
w
New wire tie
7. Route the supply wire harness along the same path as
the existing factory wire harness.
8. Install one new wire tie between the electrical box
and the strain relief to secure the new supply wire
harness to the existing factory wire harness.
qq
qq
qq
qq
ww
49 Securing the supply wire harness with new wire ties
q
New wire tie locations
w
Strain relief
9. Use the remaining three new wire ties to secure the
rest of the new supply wire harness.
10. Replace the electrical box cover and secure it in
place with the two electrical box cover screws.
11. Push the electrical box foam back to its original position.
I
The wires on the le side can sit on top of the
electrical box foam if necessary.
8.3.5 Connecting the new compressor
wire harness
NOTICE: When routing the compressor wire harness,
the compressor wire harness should route under the
foam. Failure to follow this notice could cause the fan
motor sha to damage the compressor wire harness.
qq
ee
rr
tt
ww
50 Connecting the compressor wire harness
q
White compressor
wire terminal R(U)
r
Blue compressor wire
w
Compressor
t
Red compressor wire
terminal S(V)
e
Compressor wire
harness
1. Using the compressor wire harness from the
installation kit, connect the white, red, and blue wires
to the compressor.
qq
ee
rr
rr
ww
51 Routing the compressor wire harness
q
Compressor cap
nut and washer
e
Compressor wire
harness path
w
Compressor cap
r
Wire ties
To Next Page
Loading...
