32
EN
Installation RV So Start Accessory
q
AC shroud
e
EPP foam
w
AC shroud screws
1. Using the #2 Phillips screwdriver, remove and set
aside the six AC shroud screws and the AC shroud.
I
The AC shroud should li off easily. If it does
not, verify all the AC shroud screws have been
removed.
2. Remove the EPP foam by pulling up vertically on the
sides and set it aside.
8.4.2 Removing the putty
qq
qq
56 Putty location and placement
q
Putty
1. Remove the putty securing the wiring in the EPP foam
wire channel.
I
Retain the putty as it will be used to re-secure
the wiring later in the installation process.
2. Place the putty on the unit to keep it free of debris.
8.4.3 Removing the nuts and washers
qq
ww
57 Mounting nuts
q
Mounting nut
w
Washer
1. Remove the mounting nuts mounting the fan motor to
the motor mount.
2. Remove the washers from the mounting studs and
discard or recycle.
I
Do not use sharp objects to remove as it can
damage the bushing/grommet.
To Next Page
Loading...
