Steering System
ST-9
Check
Ball head pin assembly
1.Check the ball head pin travel. If there is damage, too large
axial clearance or hard move of the ball head pin, replace the ball
head pin assembly.
Transverse swing force(measuring point: cotter pin) A:
See "Maintenance data and explanation".
Driving moment B:
See "Maintenance data and explanation".
Axial clearance C:
0mm
2.Check the working condition of the dust proof. If it had been
damaged, replace immediately.
a.When replacing the dust proof, pay much attention to it and
do not damage it.
b.Use the li-based grease to lubricate the ball head pin if nec-
essary.
c.Install the dust proof by the special tool, and be careful never
let the dust proof over expansion.
Note:
Be careful and never let the grease on the tapered part of the bal
head pin.
Drag link and tie-rod
Check the tie-rod and the related rods for any break, bend or
crack, replace if necessary.
Fixing and adjusting part:
Check each connecting part (bolt and cotter pin) for any loose-
ness, clearance or damage.
If there is looseness or extra clearance, check the ball head pin
for damage.
When reassembling the ball head pin, use a new one.
To Next Page
Loading...