34
2358-065 Issued 7-19
Version E
The tracker expansion interface board sends the following gate operator data to the DKS access control system. This data is stored in a
separate file in the access control system and can be viewed by clicking the GATE button on the transaction report screen in the DoorKing
Remote Account Manager for Windows software. Each event is date and time stamped.
Gate Operate 100 Times
Gate Forced
Gate Hit Obstruction
Gate Power On
Gate Key 1 On 5 Minutes
Gate Key 2 On 5 Minutes
Gate Reverse On 5 Minutes
Gate 5/14 On 5 Minutes
Gate Input On 5 Minutes Rels
Gate Stop On 5 Minutes
Gate Reverse Loop On 5 Minutes
Gate Exit Loop On 5 Minutes
1601 Up On 5 Minutes
1601 Down On 5 Minutes
1601 Up Loop On 5 Minutes
1601 Up Loop Down 5 Minutes
1601 Power On
1601 Input On 5 Minutes Rels
Pedestrian Gate Stuck Open
Pedestrian Gate Closed
1601 Hit Obstruction
Gate Open On 5 Minutes
Gate Close On 5 Minutes
Gate 1 Power Off
1601 Power Off
Open Beam On 5 Minutes
Close Beam On 5 Minutes
Open Edge Activated
Close Edge Activated
Gate Shut Down
Reset Pushed
Alarm On
Reset Pushed
Beam On 5 Minutes
Transaction sent each time gate operator goes through 100 operations. If 10 of these
transactions show on report, the operator has cycled 1000 (10 x 100) times.
An attempt was made to force open the gate.
The Type A (inherent) entrapment prevention device was activated.
Power applied to the operator control board.
Input is activated continuously (shorted) for at least 5-minutes.
Input is activated continuously (shorted) for at least 5-minutes.
Reverse input is activated continuously (shorted) for at least 5-minutes.
Partial open input is activated continuously (shorted) for at least 5-minutes.
Shorted input has been cleared.
Stop (3-button) input is activated continuously (shorted) for at least 5-minutes.
Detector plugged into control board reverse port activated at least 5-minutes.
Detector plugged into control board open port activated at least 5-minutes.
Up input to 1601/1602 operator activated continuously for at least 5-minutes.
Down input to 1601/1602 operator activated continuously for at least 5-minutes.
Detector plugged into control board up port activated at least 5-minutes.
Detector plugged into control board down port activated at least 5-minutes.
Power applied to the operator control board.
Shorted input has been cleared.
Alarm relay activated on 2358 tracker expansion board.
Alarm reset activated on 2358 tracker expansion board.
The Type A (inherent) entrapment prevention device was activated.
Open (3-button) input is activated continuously (shorted) for at least 5-minutes.
Close (3-button) input is activated continuously (shorted) for at least 5-minutes.
Power applied to the operator control board has been lost.
Power applied to the operator control board has been lost.
Input is activated continuously (shorted) for at least 5-minutes.
Input is activated continuously (shorted) for at least 5-minutes.
Reverse edge has been activated.
Reverse edge has been activated.
Slide gate hard shutdown, entrapment alarm activated.
Slide gate reset button activated.
Swing gate hard shutdown, entrapment alarm activated.
Swing gate reset button activated.
Swing gate beam input is activated continuously (shorted) for at least 5-minutes.
5.3 Gate Operator Event (transaction) Reports
Event (transaction) Description
To Next Page
Loading...
