Safety Section
-8-
Overhead Guard Must Be In Place Warning
WARNING
Operation without this device in place may be
hazardous. This guard conforms to A.N.S.I.B56.1
and F.E.M. Section IV. This design has been tested
with an impact of (appropriate value).
Located on the Overhead Guard.
Brake Pedal Adjustment Warning
WARNING
Improper adjustment could result in injury or death.
It has to be adjusted by drawing dimension on free
condition. For safe, don’t unfasten clevis and nut. It
has to be adjusted by trained personnel.
Located inside Brake pedal box.
Electrical Parking Brake
Push the front side of the parking brake switch
to engage the brake.
Pushe the rear side of the parking brake switch
to engage the brake.
Applying the parking brake puts the transmission in
NEUTRAL. The parking brake must be applied when
leaving the lift truck and when starting the engine. If the
operator leaves the seat without applying the parking
brake, an audible alarm will sound.
WARNING
When leaving machine apply parking brake!
Parking brake is not automatically applied.
Alarm will sound if parking brake is not applied.
WARNING
Correct adjustment is necessary to provide
adequate braking. See the MAINTENANCE section
for adjustment procedures. The lift truck may creep
at engine idle and can cause damage, injury or death.
Always apply the parking brake when leaving the lift
truck. The parking brake is NOT automatically
applied.
To Next Page
Loading...
Need help?
General
