Maintenance Section
-140-
Fuses, Bulbs & Circuit Breaker -
Change, Reset
Fuses
NOTE: If a fuse filament separates, use only the same
type and size fuses for replacement. If the
filament in a new fuse separates, have the
circuits and instruments checked.
NOTICE
Always replace fuses with ones of the correct ampere
rating.
Remove the front cover from the box. The fuses are in
the box.
Fuse - Protects an electrical circuit from an
overload. Opens (filament separates) if an
overload occurs.
Fuses are identified as follows :
1. Horn - 10 A
2. Head Lamp ,Clearance Lamp, Tail Lamp - 15 A
3. Lamp Relay Coil, Fwd/Rev. Solenoid, Rear Lamp
Relay & Back-up Lamp/Alarm - 15 A
4. Instrument Panel, Hour Meter, Preheat Controller,
Fuel Shut off Solenoid - 15 A
5. Stop Lamp, Turn Signal Lamp, Strobe Lamp - 15 A
6. Starter Relay - 10 A
Bulbs
Bulbs are identified as follows:
[ Diesel Engine]
1.
Bulb - head lamp halogen (24V - 55W)
*2. Bulb - back up (24V - 10W)
*3. Bulb - turn signal (24V - 25W)
*4. Bulb - stop & tail (24V - 25/10W)
*Optional lamp or light
To Next Page
Loading...
Need help?
General
