Operation Section
-81-
Seat Switch System
The lift truck is equipped with a SEAT SWITCH
SYSTEM. In normal operation if the direction lever is
placed in either forward or reverse, the lift truck will
move at a speed proportional to the accelerator
pedal's position. If the operator leavers the seat
without setting the parking brake, within three
seconds after leaving the seat, the SEAT SWITCH
SYSTEM will automatically disengage the
transmission. The directional lever, however, will
remain in that forward or reverse location although
internally the transmission will have shifted into
neutral.
Before exiting the lift truck, the parking brake should
always be applied.
WARNING
WHEN LEAVING MACHINE APPLY PARKING
BRAKE!
PARKING BRAKE IS NOT AUTOMATICALLY
APPLIED.
NOTE: Some trucks may be equipped (ask your dealer
if this applies to your truck) with an alarm that
will sound if the parking brake is not applied
when leaving the machine.
NOTICE
1. Prior to operating the lift truck, be sure to understand
and check the SEAT SWITCH SYSTEM.
2. While in normal operation and on level ground, select
a direction with the directional lever and with the park
brake released. You will note that the truck will move
slowly in the selected direction. If you lift yours hips
off of the seat, within three seconds, the SEAT
SWITCH SYSTEM will desengage the transmission
allowing the truck to coast but not automatically stop.
3. To restore the lift truck to normal operation, while
sitting in the operator's seat depress the brake pedal
to hold the lift truck, return the directional lever to the
neutral position, and then reselect a direction of travel
(either forward or reverse). The transmission will then
re-engage.
4. If seat or seat switch replacement becomes
necessary, be sure to use genuine DOOSAN lift truck
parts. Lift trucks should never be operated without an
operational SEAT SWITCH SYSTEM.
To Next Page
Loading...
