Operation Section
-92-
After Starting the Engine
Observe all indicator lights and gauges frequently during
operation, to make sure all systems are working properly.
All of the indicator lights will come ON with the ignition
switch in the ON position before the engine is started.
Diesel Engine
1. The engine oil pressure indicator light (1), will
not come ON with the engine running, unless
there is low or no oil pressure. Stop the engine
immediately, if the light comes ON.
2. The alternator indicator light (2), should not
come ON during normal operation. The alternator
is not charging if the light comes ON with the
engine running.
3. The engine MIL (Malfunction Indicator Light)(3)
will not come ON with engine running, unless the
fault or faults are stored in the memory of the
engine control module (ECM). Stop the engine and check
the electric engine control system if the light comes ON.
Refer Engine of this section.
The engine MIL(Malfunction Indicator Light) will not come
on with engine running.
If MIL does not disappear, please contact service center.
4. Observe the diesel fuel level gauge (4) for
fuel level in the tank.
5. The engine coolant temperature gauge
pointer (5), will be in the green band with the
engine running, unless the coolant
temperature is excessive.
6. Observe the hour meter (6) to make sure it
is operating properly.
To Next Page
Loading...
