Maintenance Section
-115-
Parking Brake Forced Release Method 2 (In
Case That the Engine Does Not Start)
1. Secure the tires with wooden blocks.
2. Use a hex wrench to fully loosen the plugs in the
three o’clock and nine o’clock directions on the front
of the transmission.
3. Temporarily tighten the M8 x 30mm bolt by hand.
4. Use a spanner to tighten the two bolts alternately
(one bolt at a time) by one turn each. (Caution: Avoid
using a pneumatic impact or power tool to fully
tighten the bolts as it may cause damage to the
internal parts.)
Restoration of Parking Brake Forced
Release Method 2
1. Secure the tires with wooden blocks.
2. Use a spanner to loosen alternately by one turn each
the two bolts (one bolt at a time) assembled in the
three o’clock and nine o’clock directions on the front
of the transmission. (Caution: Avoid using a
pneumatic impact or power tool to fully loosen the
bolts as it may cause damage to the internal parts.)
3. Apply sealant to the plug (previously removed) and
fully tighten it with a hex wrench.
4. Start the engine and check that the parking brake
functions normally.
To Next Page
Loading...
