Safety Section
-18-
Operator Restraint System (If
Equipped)
Warning Signs and Labels
Your DOOSAN lift truck has the following tipover
warning decals.
Make sure that you can read all safety signs. Clean or
replace these if you cannot read the words or see the
pictures. When cleaning the labels use a cloth, water and
soap. Do not use solvent, gasoline, etc. You must replace
a label if it is damaged, missing or cannot be read. If a
label is on a part that is replaced, make sure a new label
is installed on the replaced part. See you DOOSAN Lift
Truck dealer for new labels.
The most effective method of preventing serious injury or
death to yourself or others is to familiarize yourself with
the proper operation of the lift truck, to be alert, and to
avoid actions or conditions which can result in an
accident.
WARNING
Tipover can occur if the truck is improperly operated.
In the event of a tipover, injury or death could result.
The “Survive in tipover” warning is located on the
overhead guard. It shows the proper use of the operator
restraint system.
Seat Adjustment
Move the lover, slide the seat to the desired position, and
release the lever.
Adjust the seat before operating the lift truck. After
adjusting, set the seat to make sure it is properly locked.
Do not adjust the seat while the truck is in motion.
WARNING
Do not pace your hand or fingers under the seat.
Injury may occur as the seat moves up and down.
To Next Page
Loading...
