Operation Section
-69-
Weight Scale Mode (Optional - Hydraulic)
This option enables the operator to measure and limit the
weight of the load using the LCD display. Use “WEIGHT
SCALE” under the “VEHICLE” menu.
Zero Setting
Raise the forks by 1 m as unloaded and press ENTER to
set the weight of the mast assembly to be zero.
Load Setting
Prepare a reference load whose weight is accurately
known and enter its weight into the display. Put the
reference load on the forks and raise the forks. And then
press ENTER to complete the setting of a reference load
value.
Since the weights of any loads will be measured based on
this reference load value, it must be accurately set.
Rated Load Setting
Enter the rated load capacity of the vehicle into the display
and press ENTER to complete the setting of the rated load
value.
An overload warning will be given if any weight exceeding
the rated load entered is measured.
To Next Page
Loading...
