G643(E) Service Manual Chapter 4. Engine Electrical System 121
EST Distributor
Remove Distributor
1. Disconnect coil harness (1) from distributor.
2. Bring the engine to TDC on the compression
stroke before removing the distributor.
3. Remove the coil wire, spark plug wires (3) and
cap (4) from the distributor.
NOTE: Scribe an alignment mark on the distributor
and intake manifold to show the position of the rotor.
4. Remove the bolt, distributor clamp, and distributor.
Install Distributor
1. Install the distributor (1) in position in the intake
manifold. Make sure that the rotor (2) is in
alignment with the scribe mark and number one
cylinder.
2. Install the distributor clamp and bolt to the
distributor.
3. Install cap (4) and plug and coil wires to the
distributor.
4. Connect the coil harness to the distributor and the
coil wire to the coil.5.Check the ignition timing.
(See Test and Adjustment)
To Next Page
Loading...
