dormakaba USA Inc. System User Guide 7040.0320 | 28
3.9.3 Buzzer Mode
The Buzzer provides sound to signal specific functional outcomes.
3.9.3.1 Buzzer Mode – Display Keypad
Follow these steps to toggle the Buzzer Mode On and Off on a Display Keypad:
1. Navigate through the Main Menu and select System.
2. Select Buzzer from the sub-menu.
3. Select Between Yes and No to Enable/Disable Buzzer Mode.
4. Success Mode updated will appear on screen and the Keypad will beep twice and flash a green LED once complete.
3.9.3.2 Buzzer Mode – Non-Display Keypad
Follow these steps to toggle the Buzzer Mode On and Off on a non-Display Keypad:
1. Using the Keypad, input #41 + Authorized User ID and Combination + Off (0) or On (1) + Return Key.
2. The Keypad will beep three times and flash a green LED once complete.
3.9.4 Combination Length
The Combination Length can be changed to a length between 6 and 9 digits inclusively. This feature can only be modified by a
Master user. This feature only applies to non-Master users. A Master combination is always 8 digits.
WARNING: If the combination length is changed after any users have been entered into the system, those users will need to reset
their combination before they can perform any operations. After a user’s combination is reset, the user will then need to change
their combination again in order to use the system. Since the Master User is the only one whose combination is unaffected by
change in Combination length, the Master must reset other users’ combinations. Once a Manager’s Combination is reset and then
changed again, the Manager can reset other users’ combinations.
3.9.4.1 Combo Length – Display Keypad
Follow these steps to change the combination length on a Display Keypad:
1. Navigate through the Main Menu and select System.
2. Select Combo Length from the sub-menu.
3. Input the # of Digits with the Keypad. Confirm the selection with the Return Key. For UL certification, the combination must be
a minimum of 6 digits long.
4. Success Length updated will appear on screen and the Keypad will beep three times and flash a green LED once complete.
3.9.4.2 Combo Length – Non-Display Keypad
Follow these steps to change the combination length on a non-Display Keypad:
1. Using the Keypad, input #11 + Master User ID and Combination + Digit Length (from 6 – 9) + Return Key.
2. The Keypad will beep three times and flash a green LED once complete.
To Next Page
Loading...
