Dormakaba 705 - User Mode; User Mode - Display Keypad; User Mode - Non-Display Keypad

dormakaba USA Inc. System User Guide 7040.0320 | 29
3.9.5 User Mode
The User Mode is a system setting that determines how many Users and what class of user can gain access to the Keypad and
applies to all locks connected to the System. The User Mode can only be set by the Master.
Table 6 – User Modes
Mode
Lock Access
Notes
Single
1 Access User or 1 Manager
Single user is the default User Mode for safe locks
Dual
2 Access Users or 1 Manager
Requires 2 Users to authenticate. Duress can be signaled by either user
combinations.
Dual + Mgr
2 Access Users or 1 Access User + 1
Manager or 2 Managers
Requires 2 non-Master IDs to authenticate.
3.9.5.1 User Mode – Display Keypad
Follow these steps to change the User Mode on a Display Keypad:
1. Navigate through the Main Menu and select System.
2. Select User Mode from the sub-menu.
3. From the list provided, select between Single, Dual and Dual + Mgr.
4. Success Mode updated will appear on screen and the Keypad will beep three times and flash a green LED once complete.
3.9.5.2 User Mode – Non-Display Keypad
Note: This function is not available on the 701 series of Keypad,
Follow these steps to change the User Mode on a non-Display Keypad:
1. Using the Keypad, input #12 + Master ID and Combination + User Mode (0 = Single User, 1 = Dual User, 2 = Dual User + Mgr) +
Return Key.
2. The Keypad will beep three times and flash a green LED once complete.