Dover markem-imaje SmartDate 5 - Page 156

SECTION 5 - TROUBLESHOOTING
5-10
SmartDate 5 06/08
Fault Message 1209 - Print Go Expected While Substrate Moving
Description
Possible
Causes
The print trigger sensor has been triggered before the
substrate has stopped moving. (Intermittent printer)
Remedial
Action
Check the sensor.
Fault Message 1210 - Encoder Failed
Description
Possible
Causes
The Encoder signal is not being received when Print Go
signals are active.
Remedial
Action
Check the Encoder.
Fault Message 1211 - Printhead Prime Failure
Description
Possible
Causes
Printer hardware fault.
Remedial
Action
Notify Markem.Imaje
Table 5– 1: Fault Messages