SECTION 5 - TROUBLESHOOTING
5-15
SmartDate 5 06/08
Warning Message 2100 - Image Not Ready
Possible
Causes
The SmartDate 5 was unable to locate the image due to a
timing issue
Remedial
Action
Reduce the pack rate speed or reduce the number of updating
fields on the image.
Warning Message 2101 - Missed print
Possible
Causes
The SmartDate 5 was unable to print the image due to a speed
or timing issue. (Continuous printers)
Remedial
Action
Run a Speed profile to see if the print is occurring at the
correct point of the packaging machine cycle.
Warning Message 2102 - Truncated Print
Possible
Causes
The length of the image plus the amount of registration
(Intermittent printer) exceeds the distance that the print
module can travel.
Remedial
Action
Reduce the amount of registration.
Warning Message 2103 - Cropped Print
Possible
Causes
The image has been designed with fields which are off the
printable area.
Remedial
Action
Re-design the image.
Warning Message 2104 - Max Print Width Exceeded
Possible
Causes
The image width exceeds the maximum print width setting.
Remedial
Action
Reduce the width of the image or adjust the image width
setting.
Table 5– 2: Warning Messages
To Next Page
Loading...