SECTION 5 - TROUBLESHOOTING
5-36
SmartDate 5 06/08
5.14 Checking Database Information
5.14.1 Local
You can check whether the Job is present in the local memory by scrolling
through the database using SELECT JOB. If the Job is not visible then it is not
present.
5.14.2 Host
You can check whether the Job is present on the PC by looking in the Job
Manager in the CoLOS Create Pro Software or Selecting a Job in CoLOS Control.
5.14.3 Database mode
You must have the correct mode selected on the SmartDate 5 for Job selection to
be possible.
If it is a stand-alone SmartDate 5, you should be in Local mode. If you are part of
a network of SmartDates connected to a PC, then you could be using Local mode
or you could be in Host mode, depending on the particular application.
To determine whether you are in Local mode or Host mode, select a product using
the SELECT JOB command. The selection screen will indicate which mode you
are in.
If a list of Jobs is displayed, then the SmartDate 5 Local Database is being used.
If the Job name has to be entered manually then the SmartDate 5 is set to use a
Host PC.
To Next Page
Loading...