Choose a Mounting Location for the Controller and Printer. Choose an indoor mounting location where it will be
protected against moisture and extreme temperature and humidity conditions.
Wall mount the Controller at eye level close to a circuit breaker. Leave room above and below Controller for
power, probe, sensor, remote alarm, and other conduits that must be connected to the Controller.
If purchased, also leave room for the optional printer that normally mounts to the left of the Controller.
1.6 Mounting the Controller
Mount the Controller to the wall using the dimensions shown in Figure 4 on page 19. The four (4) mounting
holes are 0.80 cm (0.3125 in) diameter. Use as large a fastener as possible.
To Next Page
Loading...
