5. Attach the ground wire to one of the ground terminal studs (near the top knockouts marked as ground_
and run back to the main distribution panel for connection.
NOTE: The ground wire must be #12 AWG or larger.
Some countries/states require a redundant ground wire; this should be attached to the second ground
terminal stud and run back to the main distribution panel for connection.
Power wiring must enter the Controller via the designated power conduit knockout.
Connect the power wires to a dedicated circuit.
See Specifications on page 10 for power requirements.
Protecting communication ports and ensuring site intrinsic safety for the SiteSentinel iTouch
Proper Grounding of the SiteSentinel iTouch is essential for protecting the communication ports and lessens
the risks of hazardous situations occurring when power surges or lightning strikes happen. This document
outlines the recommended practices for a safe and damage-free installation.
To Next Page
Loading...
