Dr.Muller SUPER GL easy - Plasma Reference Glucose; Functions When Switching on Device; Set Time; Washing

Operation – Part 2
20.08.2012 Page 31 of 42 Rev. 04
5.2.2.6 Washing
The display shows “Washing” in the first row; “YES / NO” in the second row,
matched to the keys. After confirmation with “YES” the tube system is washed
for 100 seconds.
5.2.2.7 Set time
After pressing ENTER, the first row of the display shows the current time in the
device. The second row displays “OK” beneath ENTER and “Set” beneath MENU.
By pressing Menu briefly, you can count up the minutes in single steps; holding
the button counts up the minutes more quickly. Setting the time can only be
done in this direction. After reaching the desired time, press ENTER to confirm.
5.2.2.8 Plasma reference glucose
As described in chapter 3.3.3, the SUPER GL easy+ could display the measured
whole blood samples as plasma reference values. So it is necessary to adjust this
function. This happens in this menu item.
For switching on you have to do following steps:
Plasma ref YES / NO  YES  Plasma ref ON / OFF  ON  Plasma ref YES /
NO  NO  Stand by “Function Menue”
For switching off the plasma reference you have to do the same steps (but:
Plasma ref ON / OFF  OFF).
Because of the red colour of whole blood samples the device is able to difference
between samples of whole blood and other sample materials (i.e. serum, plasma,
fluid).
Please take notice if this function is activated or not, if you have not plausible
values.
5.3 Functions when switching on
After switching on the device, some tests of internal systems and the inserted
card are carried out (see also function of cards and troubleshooting). Among
other things, information about the available supply on the card and the
remaining lifetime of the sensor are displayed.
If you press ENTER until you hear a beep while switching on the device, you
reach the menu for activating and deactivating controls. This function allows you
to activate a maximum of three controls per method for quality control statistics
purposes. To activate press ENTER, to deactivate press MENU. The position of
the star displays the current state.