Dr.Muller SUPER GL easy - Functions of the Cards

Operation – Part 2
20.08.2012 Page 34 of 42 Rev. 04
Sensor lactate:
The following adjustments are valid:
DIL 1: Adjustment for unit lactate (ON = mg/dl and OFF = mmol/l)
DIL 2: Adjustment for unit hemoglobin

(ON = g/dl and OFF = mmol/l)
DIL 3: Switching on / off measuring lactate (ON = determination of lactate;
OFF = no determination of lactate)
DIL 4: Switching on / off measuring hemoglobin

(ON = determination of
hemoglobin; OFF = no determination of hemoglobin)
Sensor hemoglobin:
The following adjustments are valid:
DIL 1: Adjustment for unit hemoglobin (ON = g/dl and OFF = mmol/l)
DIL 2: irrelevant
DIL 3: Switching on / off measuring hemoglobin

(ON = determination of
hemoglobin; OFF = no determination of hemoglobin

)
DIL 4: irrelevant
Please note while measuring with sensor hemoglobin
that DIL switch 3 is turned to ON, otherwise the
device will not display any value.
5.5 Functions of the cards
The Super GL easy / easy+ is equipped with a card reader allowing various
functions to be made more user friendly. Various cards with the following
designations and functions are available:
Operation Card:
Necessary for measuring operation and supplier identification
Device Setting Card:
Enables the user to change specific device internal parameters. This
setting changes the measuring value; the cards are only made available
upon request.
Language Cards:
Change the language of the menu
It is important to insert the appropriate card before the device is switched on. If
not, an error message is displayed and the device cannot be used. When using
the special card (not operation card), the device switches itself off after carrying
out the instructions on the special card.
Before taking a measurement, the device checks how many samples can be
measured using the card and how long the sensor will remain active.
If the supply on the operation card is less than samples, a warning is displayed
both on the printer and the display. The same happens when the remaining life
time of the sensor is less than 10 days.

depending on model of equipment