DR RAPID-FEED 16.50 PRO User Manual

• WEAR EYE PROTECTION WHEN CUTTING THE BANDING. THE BANDING MAY HAVE A LOT OF
TENSION ON IT AND MAY SNAP AND CUT YOU. ALWAYS STAND TO ONE SIDE WHEN CUTTING
THE BAND.
• STABILIZE THE SHIPPING CONTAINER ON CLEAN FLAT TERRAIN BEFORE ATTEMPTING TO
UNPACK AND ASSEMBLE THE CHIPPER.
• FOR YOUR SAFETY WE RECOMMEND YOU HAVE TWO PEOPLE FOR THE FOLLOWING
PROCEDURES.
1. Cut the Plastic Banding that is securing the Parts Box
and any Accessory Box that may be strapped to the
Crate Top (Figure 5).
Plastic
Banding
Bottom
Board
Pallet
Crate Top
2. Pry off the bottom four boards that connect the Crate
top to the Pallet.
3. With help from another person, lift the Crate Top
from the Pallet.
4. Remove the Parts Box and the Road-Tow Package (if
ordered).
Figure 5
5. Carefully cut the Steel banding holding the machine
and Hopper Assembly to the pallet (Figure 6).
Hopper
Assembly
Steel
Banding
Chipper
Assembly
Plastic
Banding
Steel
Banding
6. Cut the Plastic Banding that is holding the Extended
Top-Discharge Chute (if ordered) to the Pallet and
remove the Extended Top-Discharge Chute.
7. With the help of another person, carefully remove the
Hopper Assembly and roll the 16.50 PRO DR RAPID-
FEED CHIPPER from the shipping pallet, resting it on
the Tongue Assembly.
8. Compare the contents of the shipping carton and the
Part Box with the Parts Supplied list on the previous
page. If there are any questions contact us at
www.DRpower.com or call 1-800-DR-OWNER (376-
9637). Do not discard the shipping materials until
you are fully satisfied with your new 16.50 PREMIER
DR RAPID-FEED CHIPPER.
Fi
g
ure
6
CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 15

DR RAPID-FEED 16.50 PRO Specifications

General

Brand	DR
Model	RAPID-FEED 16.50 PRO
Category	Chipper
Language	English