CHAPTER 5
MAINTAINING THE 16.50 PRO DR RAPID-FEED CHIPPER
This chapter covers regular maintenance procedures that will ensure the best performance and long life
r’s Manual
isted in the
Maintenance Kits and Accessories are available through our website at www.DRpower.com.
of your DR RAPID-FEED CHIPPER. For engine maintenance, please refer to the Engine Owne
that came with your machine. Service intervals listed in the checklist below supercede those l
Engine Owner’s Manual.
SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP, REMOVE
SPARK PLUG WIRE, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES BEFORE
PERFORMING MAINTENANCE ON THE CHIPPER.
Regular Maintenance Check List
NOTE: Consider that the service intervals shown are the maximum under normal operating conditions.
Increase frequencies under extremely dirty or dusty conditions.
Procedure
Before Each Use Every 8-10
Hours
Every 40
Hours
Check Engine Oil Level
▲
Check General Equipment Condition
▲
Check that the Flywheel turns freely (with a long stick on
ly)
▲
Visually inspect Knife for damage
▲
Check Knife and Wear Plate for Sharpness
▲
Check Knife and Wear Plate Attachment Screws
▲
Check Flywheel Bearing Collar Set Screws
▲
Check Knife to Wear Plate Gap
▲
Lubricate Flywheel Bearings
▲
Check Belt Tension and Condition
1
st
time 1 hour
▲
Clean g
▲
En ine Exterior and Cooling Fins
Check the Battery Voltage (electric start only)
▲
Check the
▲
Tire Pressure
Change Engine Oil
1
st
time 5 hours
▲
Inspect or replace Drive Belt
▲
CONTACT US AT www.DRpower.com or CALL TOLL FREE 1-800-DR-OWNER 29
Inspect or replace Spark Plug
▲
Inspect or replace Air Filter and Precleaner
▲
To Next Page
Loading...
Need help?
General
