26 16.50 PRO DR
®
RAPID-FEED™ CHIPPER
r)
1. Slowly move the Throttle Control Lever all the way to the slow position (turtle icon).
2. ine. The Key has a pressure lock that prevents it from vibrating
loose during operation. To remove the Key, push it in and then quickly and firmly pull it out. If the
Key becomes difficult to remove, spray FLUID FILM
®
or a similar non-conductive lubricant into the
keyhole.
NOTE: Close the Fuel Shut-Off Valve when transporting or storing the DR RAPID-FEED CHIPPER.
Stopping the Engine (Electric –Starting Chipper)
ttle Control Lever all the way to the slow position (turtle icon) and turn
Starter Switch to the “OFF” position.
2. Remove the Key for safety. The Key has a pressure lock that prevents it from vibrating loose during
operation. To remove the Key, push it in and then quickly and firmly pull it out. If the Key becomes
difficult to remove, spray FLUID FILM
®
or a similar non-conductive lubricant into the keyhole.
NOTE: Close the Fuel Shut-Off Valve when transporting or storing the DR RAPID-FEED CHIPPER.
Stopping the Engine (Manual –Starting Chippe
THE F W SHUT OFF. SHUT DOWN
THE ENG COMPLETE STOP, REMOVE SPARK
PLUG WIRE
Remove the Key to shut off the eng
1. Slowly move the Thro the
NEVER ST EVER TO THE CHOKE POSITION. THIS COULD
CAUSE AN GE.
OP THE ENGINE BY MOVING THE CHOKE L
ENGINE BACKFIRE RESULTING IN ENGINE DAMA
NEVER STOP THE ENGINE BY MOVING THE CHOKE LEVER TO THE CHOKE POSITION. THIS COULD
CAUSE AN ENGINE BACKFIRE RESULTING IN ENGINE DAMAGE.
LY HEEL WILL STILL ROTATE FOR A WHILE AFTER THE ENGINE IS
INE, WAIT FOR ALL MOVING PARTS TO COME TO A
THEN WAIT 5 MINUTES BEFORE MOVING OR WORKING ON THE CHIPPER.
THE FLYWHEEL WILL ST SHUT OFF. SHUT DOWN
THE E OMPLET P, O K
PLUG WIR , THEN WAIT 5 MINUTES BEFORE
MOVING
ILL ROTATE FOR A WHILE AFTER THE ENGINE IS
NGINE, WAIT FOR ALL MOVING PARTS TO COME TO A C
E, DISCONNECT THE NEGATIVE BATTERY CABLE
OR WORKING ON THE CHIPPER.
E STO REM VE SPAR
To Next Page
Loading...
Need help?
General
