NM2C SOFTWARE UPDATE PROCEDURE (continued)
-- Move the flashing cursor to the STOP column and press ENTER. Use the
up or down arrow key to select the desired stop bit, and press ENTER
again. The cursor will start flashing.
-- Move the flashing cursor to the DATA column and press ENTER. Use the
up or down arrow key to select the desired data bits, and press ENTER
again. The cursor will start flashing.
-- On the ORDM keyboard, press ESC to return to the SST Main Menu. (Use
F10 on the external PC.)
7.6.2 Set Time and Date
The Set Time and Date screen shown in Figure 7-5 allows verification and
setting of the machine’s clock.
-- At the SST Main Menu, move the cursor to SET TIME AND DATE and
press ENTER.
-- Follow the on-screen instructions for setting the month, day, year, hour
and minute.
MACHINE ID: NM2C
SERIAL NUMBER: 00011066
SV50103
SOFTWARE VERSION: 1.20
SYSTEM FEATURES: 0003
SST Date & Time: 07-MAR-1995 11:42
UUT Date & Time: 07-MAR-95 11:42:27
CHANGE UUT DATE & TIME:
MONTH DAY YEAR HOUR MINUTE
APR 13 1994 11 42
F10 PREVIOUS MENU
Figure 7-5: SET TIME AND DATE SCREEN
Rev. G
7-9
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
To Next Page
Loading...
