Dräger Narkomed 2C - Page 218

SOFTWARE UPDATE PROCEDURE (continued) NM2C
7.6.7 Service Log
This screen displays the service log of the machine showing a list of normal and
failed events, error events, service and calibration events. See Figure 7-10.
-- At the Primary Service Menu (described earlier) set the cursor at
SERVICE LOG and press ENTER.
MACHINE ID: NM2C
SERIAL NUMBER: 00011066
SV50106
SOFTWARE VERSION: 1.20
SYSTEM FEATURES: 0003
001
002
003
004
005
006
007
008
F10 PREVIOUS MENUF1 SAVE
12-07-95
12-07-95
12-07-95
12-07-95
12-07-95
12-07-95
12-07-95
12-07-95
09:17
09:16
09:13
09:11
09:09
09:08
09:07
09:06
00000005
ORDM
ORDM
ORDM
ORDM
06000400
ORDM
06000400
TEO1
V001
V003
V002
V001
0000
V001
0000
ENTERING
VTLK COM
VTLK COM
VTLK COM
VTLK COM
SOFTWARE
VTLK COM
SOFTWARE
TESTMODE
ERROR
REGAINED
LOST
ERROR
STARTUP
ERROR
STARTUP
Figure 7-10: SERVICE LOG SCREEN
-- Use the up and down arrow keys to scroll through the log; PGUP and
PGDN keys to move from page to page in the log.
-- To copy the service log to the disk drive in the ORDM or the external PC,
press the F1 (save) key.
-- To clear the service log, press the DRUGS key on the ORDM (F3 on the
external PC). (This function is not available in the VIEW mode.)
-- Press ESC on the ORDM (F10 on the external PC) to return to the
Primary Service Menu. If desired, press ESC (or F10) again to return to
the SST Main Menu.
Rev. G
7-14
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO THIS MANUAL'S TABLE OF CONTENTS